Settings

Settings Menu Guide

The following is a brief description of each of the items in the settings menu.

Repetition Configuration

This section allows the user to configure timing parameters related to the “On your marks” and “GO” signals.

Starters Pause

This is the pause time between the “On your marks” sound and the “GO” sound.

  • The default is a fixed pause time of 2.0 seconds.
  • The step resolution is 100 milli seconds.
  • Disable fixed mode and the pause time will be random by up to 2.4 seconds.
Repeat Interval

This is the time in seconds between “GO” signals.

  • The default is 10 seconds.
  • The step resolution is 10 seconds.
Enable Continuous mode

When enabled, the “On your marks” and “GO” signals will be repeated forever at the repeat interval, or until the stop button is pressed.

When disabled the user can set the race repetitions to limit the number of repeats.

Race Repetitions

This is simply the number of times that the “On your marks” and “GO” signals will be played.

Sounds

This section provides selection of the “On your marks” and “GO” sounds.
There are several built in sounds available or custom sounds can be selected from your music library.

On Your Marks Sound
  • This is the sound played just prior to the start signal.
  • The default is a recording of a person saying “On your marks”
  • Select a custom sound from your music library.
  • Custom “On your marks” sounds must be less than 2 seconds.
Go Sound
  • Is the sound played when the count down ticker reaches zero (“GO”).
  • The default is a short burst siren.
  • Select a custom sound from your music library.
Custom Sounds:
  • Can be copied into the music library on your Apple device via iTunes.
  • File format must be either mp3 or m4a.
  • Are limited to a maximum of 2 seconds.

Pace Clock

Synchronise the SwimStart app to an external pace clock.

If the swimmers can’t see the Swim Start count down ticker, or prefer using the big pace clock on the wall, then you are able to synchronise the Swim Start pace clock to the external clock.

Remote Control/Replicate

When Swim Start is configured for remote mode, it can Start and Stop another device running Swim Start in Primary mode.

Swim Start running in Remote mode will synchronise the pace clock and count down ticker with the Primary.

Enable Remote Control
  • Enables remote control and replicate mode.
  • Must have bluetooth enabled.
  • The device must support Bluetooth Low Energy.
Mode
  • Select either Primary or Remote modes.
  • There must be one Primary SwimStart enabled.
  • When Remote is selected there must be another Primary device already configured.
Connect to:
  • When Remote mode is selected you must choose a Primary device to connect to.
  • Multiple remotes may connect to one Primary device.